Home › Tile & Grout
Grout is porous, so years of dirty mop water soak into it and no amount of mopping lifts it back out. Pressurized hot water flushes the dirt back out of the grout and vacuums it up on the spot, taking the color back to the one it was laid in.
What West Michigan homeowners ask us most about tile floors.
Because the dirt is not on the grout, it is in it. Grout is porous, so mop water carries soil and detergent film down into it where a mop can never reach again. Every subsequent mopping pushes a little more in. High-pressure hot-water extraction is the only practical way to flush it back out.
Usually much further than people expect, because most of what makes grout look dark is embedded soil rather than permanent staining. Grout that has genuinely lost its color pigment, or been stained by something like rust or dye, will not come all the way back. Color-sealing is the answer in that case and restores a uniform color permanently.
On kitchen, bathroom, and entryway floors, yes. Sealer does not make grout stain-proof, but it slows absorption enough that spills sit on the surface long enough to be wiped up rather than soaking straight in. It is applied after cleaning, when the grout is clean and dry, and it is what makes the result last.
Yes, with the right chemistry. Ceramic and porcelain tolerate a much wider range of cleaners than natural stone does; marble, travertine, and limestone are calcium-based and will etch if hit with anything acidic. We identify the surface before we start and use pH-appropriate solutions.
Typically under an hour. Hard surfaces dry far faster than carpet because there is no pad or backing holding moisture. If grout sealer is applied, allow a few hours before heavy traffic.
Yes: restaurants, medical facilities, schools, offices, and retail throughout West Michigan, usually scheduled outside operating hours. See commercial floor care for scheduling and recurring maintenance.
